Наши контакты Доставка по всей России
  • /
Корзина (0)
Сумма: 0
Отложенные (0)
Главная Татуировочное оборудование Зап. части для машинок Зап. части DragonFly - Stingray No. 41 - Eccenter assembly SHORT STROKE 2,6mm
  • No. 41 - Eccenter assembly SHORT STROKE 2,6mm

Зап. части DragonFly - Stingray "No. 41 - Eccenter assembly SHORT STROKE 2,6mm"

2 500 ₽
Hint! Use the Circlip Pliers to remove the Circlip and push out the Connecting pin. Loosen the excenter from the motor shaft with the smallest allen key 0.9mm. There are two screws on the standard excenter, one for the motor shaft and one for the bearing shaft. You only need to use the one for the motor shaft. Install the new assembly on the motor shaft and make sure that the screw ends up on the flat part of the shaft and tighten it securely. Check that the Connecting rod aligns properly with the groove in the Piston. This is important, if it does not align correctly it will not run properly and you might have to readjust the location of the motor. In that case please refer to the manual or send for service. If ok align the upper bearing with the hole in the piston and insert the Connecting pin and install the Circlip.
Ink Machines

Только по 100% предоплате

На этот товар скидки не распространяются

Количество: + в корзину